Specification:100% brand new and high qualityMaterial: Metal + PlasticColor: BlackRated Voltage: DC 12VRated Power: 60WMaximum Flow: 5L/min(Maximum 5L/min when pumping. Viscous liquid flow rate will decrease)Maximum Pressure: 0.8MPAPump Diameter: Approx. 5 cm / 1.97"Length: Approx. 16cm / 6.3"Cable Length: Approx. 60cm / 23.62Clips Length: Approx. 8cm / 3.15"Outlet PVC pipe Length:150cmNylon pipe Length:100cmBrass pipe Length:70cmQuantity: 1 pcFeatures:How to use: Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oilConnect the pump to the power, run it for a while, and observe whether the inlet and outlet is normalOpen the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not moveThen put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely)As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets cleanIf you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all outIncluded:1x Oil Pump1x 11mm Outlet PVC pipe1x 5mm copper pipe1x 6mm Nylon pipe
